Description
Connectors for Drip Pipe, Installation Hose, Supply Hose 16mm
The installation of the connectors is very simple. Cut the hose straight with a sharp knife (cutter), so that a clean cut edge is formed. Then, insert the connector. In low temperatures, installation can be made easier by lightly heating the connector (e.g., with a hot air gun). Using additional hose clamps is not necessary.
The connectors are made from high-quality plastic and are UV-resistant. This ensures a long lifespan and high reliability in the operation of your irrigation system.
- Color: Black
- Recommended maximum pressure: 1.8 bar (pre-installed pressure reducer)
- No hose clamps required
- Rotatable internal thread with flat gasket
- UV-resistant
- Compatible with all drip and installation hoses with a 16mm outer diameter PN4
Note: For items with a nut, it is freely rotatable and comes with an internal flat gasket.
Note: Connectors for drip pipes or installation pipes are not suitable for installation with hoses. The sharp-edged ribs are designed to press into the LDPE pipe (drip pipe, installation pipe). With a hose, this would damage the inner layer, the hose core.
Important: Do not use ball valves for pressure applications! The maximum pressure rating is 1.8 bar – be sure to use a pressure reducer so that pressure fluctuations do not negatively impact your installation system.
End piece "8" End Cap
The supply pipe is bent at the end and fixed with the "8" shaped fitting, stopping the flow easily.
Provider identification:
is a europaweit Europe-wide protected, registered trademark of HT CONNECT GmbH & Co. KG
HT CONNECT GmbH & Co. KG
Norisstraße 4
91257 Pegnitz
E-Mail: info@ht-connect.de

Media
There are currently no media files available.