Description
HTC Valve Box
The valve box for maximum capacity – up to 12 stations possible – with compact dimensions and user-friendly features.
- Capacity up to 12 stations possible
- Steep sidewalls in the cut-out area for user-friendly handling
- Pre-punched inlet and outlet (Ø 68mm) for easy opening with a hole saw or similar tools
- Vandal-proof locking mechanism
Well-planned is half the battle
Prepare a correspondingly large hole for your valve box during construction. Fill this hole with at least 1/3 gravel or similar and place your valve box in this gravel bed. The valve box for holding your distribution unit is open at the bottom – this is for good reason. For example, water entering during rain can easily drain away or seep into the gravel bed. It is also beneficial if the valve box is located in a general gravel area. To prevent the entry of pests, sand, or dirt, it is recommended to place the valve box on fleece or geotextile and wrap it to close all openings as best as possible.
Quality and Features:
- High-impact resistant plastic in a stable design
- Valve box housing, open at the bottom: Black and lid Green
- Polypropylene resistant to UV radiation; suitable for high temperatures
- Chemical resistant and corrosion-free
- Waterproof and functional in all weather conditions
- Optimal fit: no dirt or grass between the housing and the lid
- Easy access to fittings through a large interior space
- Vandal-proof lid locking mechanism with a screw (a socket wrench is required for opening and closing)
- Chamfered lid edges protect against possible damage from lawnmowers
Properly place the valve box lid – explained simply
Step 1
Place the lid at an angle so that the side with the internal catch sits inside the valve box, and the side with the screw lock faces upwards.
Step 2
The green catch lock of the lid already locks into the lid housing, preventing damage when fully locking the lid.
Step 3
Press the side with the screw lock into the recess of the valve box body, pulling the screw upwards if necessary.
Step 4
Done – Secure your fittings in the valve box by screwing in the securing screw to prevent vandalism. A socket wrench is required for this.
Do Not Do This!
Pressing the lid on both sides may cause the hold-down catch on the underside of the lid to break.
Provider identification:
is a europaweit Europe-wide protected, registered trademark of HT CONNECT GmbH & Co. KG
HT CONNECT GmbH & Co. KG
Norisstraße 4
91257 Pegnitz
E-Mail: info@ht-connect.de
Media
There are currently no media files available.
